Gromax SD20 Hole Driller
Stock Number: 5025
Gromax SD20
Age: 2006
Condition: As Is, Where Is
Click to view larger photo
| Specification | Description |
|---|
| Work table size | 17" x 8" |
| Max. Workpiece | 24" x 10" x 6" |
| Max. travel (X, Y) | 12" x 8" |
| Quill servo travel (Z) | 12.6" |
| Manual guide holder travel | 3.5" |
| Dielectric capacity | 5.3 Gal. |
| Max. power rating | 4KVA |
| Max. current | 50A |
| On/Off time setting | 32 steps |
| Peak current setting | 16 Steps |
| Stability setting | 10 Steps |
| Layout (LxWxH) | 36" x 46" x 86" |
| Weight | 1,100 LBS |
| Work load | 400 LBS |
Equipped With:
* Provides starter hole for wire EDM
* Creates gap holes in dies or plastic molds to allow gas to escape
* For drilling all kinds of hard alloy steel
* For drilling deep and small holes where conventional drilling are inadequate
* Proportion of drilling depth and diameter as good as 200:1 above 0.5mm
* Drilling diameter from 0.2mm to 6.0mm
* For curved, globe and irregular surface drilling
* Use distilled water as dielectrics
* Low electrode wear (f 1.0mm as low as 30%)
* Accurate straightness and roundness with proper settings
* Drill diameter 1mm through 1" workpiece in less than 35 sec.
* With Dove-Tail work table construction
RC Machinery Sales Company
PO Box 563
Hampshire, IL 60140
630-927-3247
rob@rcmachinerysales.com
Asset Sales and Marketing Software for Used and Surplus Industrial Machinery and Equipment Dealers
www.MacDB2000.com
